Most Popular

  • LED Street Lights Life-cycle Cost Analysis
    In this example we compare the life-cycle costs Lucas II 84 street lights with normal incandescent lamps and the most commonly available High Pressure Sodium Street Lights with the same…
  • Magnum 6K32T and TR High-Port Density Managed Gigabit Ethernet Switches
    The 6K32T and the 6K32TR (Reverse model with ports and power supply in the rear, LEDs in the front) provide 16 fixed copper ports, and two modular slots for configuration…
  • CX-UA Series
    Memotec's CX-UA Series is a dedicated cellular backhaul platform delivering 2G, 2.5G &3G Radio Access Network (RAN) optimization for GSM and CDMA cellular operators with HSPA traffic offload capabilities. It…
  • U-Tron Lucas Flat Panel
          Introduction to our Lucas FP   {quickdown 329} FP stands for Flat Panel. So we can make use of the lenses that are widely available in the…
  • CX-U Series Backhaul Platform
    Memotec’s CX-U Series is a dedicated cellular backhaul platform delivering Radio Access Network (RAN) optimization, and A/E voice trunks compression. The CX-U reduces the bandwidth required to backhaul cellular traffic,…

Drivers and Power Supplies

cache/resized/9f832880875a069c2c1c0cf6043fe6b7.jpg

50 Watt Dimming Drivers

50 Watt Dimming Driver ...

cache/resized/9277e6d1a9114c31afa9c51fe5237fa3.jpg

U-Tron LED Boost Driver

U-Tron LED Boost Driver

cache/resized/f7d40454c906e61d121a8913b93f4834.jpg

U-Tron LED Buck Driver

U-Tron LED Buck Driver

50 Watt Dimming Driver for LED

50 Watt Dimming Drivers

 Click here 6800-PSU-050 to download datasheet.

 

Utron Logo

U-Tron announces its own LED Power Supply and High efficiency Driver for all Lucas and BatLED models.

You wanted 5 year warranty. You wanted universal power supply. You wanted >97 pfc. You wanted internal PSU. You wanted TRIAC dimmable:

And you got it from U-Tron.

6800 Psu Small

U-Tron always made its own LED Driver boards and but sometimes outsourced the AC/DC power supplies. However, the power supplies available in the market have caused serious quality problems in the industries. U-Tron has decided to develop its own reliable power supply to match the LED qualities and warranty requirments. Since our volume of Lucas Street Lights sales has exceeded the average quantity, its imperative to take charge of all our components. Thanks to our engineeres, more plans have been laid out for 6800 series of high PFC and high Efficiency PSU research and development in the coming months.

About 6800-PSU Introduction

As environmental concerns over traditional lighting increase and the price of LEDs decreases, high power LEDs are fast becoming a popular lighting solution for offline applications. In order to meet the requirements of off line lighting-such as high power factor, high efficiency, isolation and TRIAC dimmer compatibility-prior LED drivers used many external discrete components, resulting in cumbersome solutions. The New U-Tron 6800-PSU solves complexity, space and performance problems by integrating all the required functions for offline LED lighting. The New U-Tron 6800-PSU controls an isolated fly-back converter in critical conduction (boundary) mode, suitable for LED applications requiring 4W to over 100W of LED power. Its novel current sensing scheme delivers a well-regulated output current to the secondary side without using an opto-coupler. Its unique bleeder circuit makes the LED driver compatible with TRIAC dimmers without additional components. Open- and shorted-LED protection ensures long term reliability.

Available Configurations:

The standard units are made with our Lucas street lights in mind: That's means every PSU will drive a set of 3 LED boards: Each PSU power output is around 50 Watt. The modular design will allow matching with the Lucas design. Lucas I models will need only one PSU, Lucas II models will need two PSU. And Lucas III models will need 3 PSU. The same design principal will apply to all the BatLEDs series. Thanks to the advancement in the technology the size of the PSU are exact same as the old driver boards so there is no need for any structural change in the luminaries. See Table 1 for available models and working conditions.

No-Opto Operation

The New U-Tron 6800-PSU senses the output current from the primary side switch current waveform. For a fly-back converter operating in boundary mode, the equation for the output current is:

IOUT = 0.5 * IPK * N * (1 - D)

IPK is the peak switch current, N is the primary to secondary turns ratio and D is the duty cycle. Typical values of 320, 350, 400 and 500mA can be achieved by jumper selection. For non standard values contact U-Tron sales department.

Ordering Part Number

# of LEDs

Total Vout

Recommended Constant Current mA

Total Watt Output

6800-PSU-030

30

96

350

33.6

6800-PSU-036

36

115.2

330

38.016

6800-PSU-040

40

128

325

41.6

6800-PSU-042

42

134.4

325

43.68

The IC regulates the output current by adjusting the peak switch current and the duty cycle through a novel feedback control. Unlike other primary side sensing methods that need to know input power and output voltage information, this new scheme provides much better output current regulationsince the accuracy is barely affected by transformer winding resistance, switch RDS(ON), output diode forward voltage drop and LED cable voltage drop.

High Power Factor, Low Harmonics

By forcing the line current to follow the applied sine-wave voltage, the New U-Tron 6800-PSU achieves high power factor and complies with IEC61000-3-2, Class C lighting equipment Harmonics Requirement. A power factor of one is achieved if the current drawn is proportional to the input voltage. The New U-Tron 6800-PSU modulates the peak switch current with a scaled version of the input voltage. Thistechnique provides power factors of 0.97 or greater. A low bandwidth feedback loop keeps the output current regulated without distorting the input current.

TRIAC Dimmer Compatible

When the TRIAC dimmer is in the off state, it's not completely off. There is considerable leakage current fl owing through its internal filter to the LED driver. This current charge-up the input capacitor of the LED driver, causing random switching and LED flicker. Prior solutions added a bleeder circuit, including a large, expensive high voltage MOSFET. The New U-Tron 6800-PSU eliminates the need for this MOSFET or any other extra components by utilizing thetransformer primary winding and the main switch as the bleeder circuit.  As shown in Figure 2, the MOSFET gate signal is high and the MOSFET is on when the TRIAC is off, bleeding off the leakage current and keeping the input voltage at 0V. As soon as the TRIAC turns on, the MOSFET seamlessly changes back into a normal power delivery device.

Fig%202

Open- and Shorted-LED Protection

The LED voltage is constantly monitored through the transformer third winding. The third winding voltage is proportional to the output voltage when the main switch is off and the output diode is conducting current. In theevent of over-voltage or open-LED, the main switch turnsoff and the capacitor at the CT pin discharges. The circuit enters hiccup mode as shown in Figure 3.

Image008

In a shorted LED event, the IC runs at minimum frequency before the VIN pin voltage drops below the UVLO threshold as the third winding can't provide enough power to the IC. The IC then enters its start-up sequence as shown in Figure 4.

Image010

CTRL Pins and Analog Dimming

The New U-Tron 6800-PSU's output can be adjusted through multiple CTRL pins. For example, the output current would follow a DC control voltage applied to any CTRL pin for analog dimming. Over temperature protection and line brownout protection can also be easily implemented using these CTRL pins.

Conclusion

The New U-Tron 6800-PSU is a complete offline LED driver solution featuring standard TRIAC dimming, active PFC and well regulated LED current with no opto-coupler. This high performance and feature-rich PSU greatly simplifies and shrinks offline LED driver solutions.

About U-Tron:

U-Tron (Beijing) Electronics Co. Ltd., was established in 1992 as a WOFE in Beijing, China. The company was 100% funded by investments from American Companies. The main purpose was to bring U.S. developed technology products to China for manufacturing and localization. U-Tron has an 1,800 square meter factory employing 50 + people in the Beijing Development Area (BDA) of Yi Zhuang district and a joint venture factory in Mapo Shunyi with Beijing Jile Electronics Company.

For more information contact This email address is being protected from spambots. You need JavaScript enabled to view it.This email address is being protected from spambots. You need JavaScript enabled to view it.

  • Last modified on Monday, 23 September 2013
More in this category: U-Tron LED Boost Driver »